Logo

U1249 Engine Code Repair

Meaning of U1249 engine trouble code is a kind of network trouble code and when the check engine light comes U1249 code on the first you should check is the gas cap. Pull over, retighten it, and take a look at the cap to see if it has any cracks in it. Continue driving and see if the check engine light turns off. Alternately, you can purchase a gas cap for about $3 at an auto parts store. All you need to do is take the old one off and screw on the new one. If you've already made it to the store, you might as well just replace it. While not car-threatening, it's good to take care of this right away to improve gas mileage.

U1249 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for U1249 code is occuring now you should check U1249 repair processes.
Now don't ask yourself; What should you do with U1249 code ?
The solution is here :

U1249 Possible Solution:

U1249 Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

U1249 Code Meaning :

U
OBD-II Diagnostic Network (U) Trouble Code For Engine

1
Fuel And Air Metering

2
Fuel Rail/System Pressure - Too High

4
Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)

9
Clutch Position Sensor Circuit Malfunction

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

U1249 OBD-II Diagnostic Network (U) Trouble Code Description

U1249 engine trouble code is about Clutch Position Sensor Circuit Malfunction.

Main reason For U1249 Code

The reason of U1249 OBD-II Engine Trouble Code is Fuel Rail/System Pressure - Too High.

U1249 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.